Overlay Installation Instructions
1st clean emblem with alcohol
Then spray emblem with a mist of water then apply the background to the emblem start in the center pushing outwards around the emblem with a squeegee or card wrapped in a paper towel push all water out from behind background use heat if you can to help dry then push vinyl into groove and use a razor knife to trim excess vinyl heat and tuck into Grove, then apply logo in same way as the background use heat to dry and peel transfer tape off.
Wheel cap overlays
Remove center cap from wheel
Then pop the toyo logo and outer ring off like in picture below
Clean very well with alcohol
Apply background, you can use the water technique like above
overlays, Then apply logo, and outer ring.